GEAppliances.com
0
¢ self-h
LCleo
• •
LTim%; L_stor
How to Delay the Start of Self-Cleaning _onsome models)
Hake sure the clock shows the correct time of
day.
[7] Latch the door.
[_ Touchthe Self Clean pad.
[_ Using the + or- pads, enter the desired
clean time.
Thedisplay will show the start time. Itwill not
be possible to unlatch the oven door until the
temperature drops below the lock temperature.
Theoven shutsoff automatically when the
clean cycle iscomplete, and 0:00 will flash in
the display.
r_ Touchthe Start Time or Delay Start pad.
Theearliest start time you can set will
appear in the display.
[] Usingthe + or- pads, enter the time of
dayyou want the clean cycle to start.
[_ Touchthe Start/On pad.
FSta rt_
LonJ
To Stop a Self-Clean Cycle
Touch the Clear/Off pad.
Wait untilthe oven hascooled below the
locking temperature to unlatch the door. You
will not be able to open the door right away
unlessthe oven has cooled below the locking
temperature.
After a Self-Clean Cycle
You may notice some white ash in the oven.
Wipe it up with a damp cloth offer the oven
cools.
If white spots remain, remove them with a
soap-filled steel wool pad and rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt residue that
cannot be removed by the clean cycle.
If the oven is not clean offer one clean cycle,
repeat the cycle.
You cannot set the ovenfor cooking until
the oven iscool enough for the door to be
unlatched.
While the oven isself-cleaning,you
can pressthe Clock pad to display the time
of day. To return to the clean countdown,
press the SelfClean pad.
Apply a small amount of vegetable oil
to a paper towel and wipe the edges of the
ovenrackswith the paper towel. Do not spray
with Pam®or other lubricant sprays.
21
To Next Page
Loading...
Need help?
General