EasyManua.ls Logo

GE Appliances Quickset III - Steam Cleaning

GE Appliances Quickset III
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Using Steam Clean. consomemode/s
[,_ ] During the steam clean cycle,
CAUTION the oven bottom becomes hot
enough to cause burns. Wait
until the cycle is over (30 minutes) before wiping the
inside surfaces of the oven. Failure to do so may result
in burns.
The Steam Clean cycle makes it easier to clean light soiling
off the standard-clean porcelain oven interior.
The range should be at room temperature before
beginning the Steam Clean cycle. If the oven is too hot,
"hot" will appear on the display and the cycle will not
activate until the oven cools down.
The Steam Clean cycle performs best on new spills or soils.
Burned-on food is more difficult to remove.
If your range has this control pad, it has a steam-cleaning oven. Follow
these instructions.
Ifnot,refertothePorcelainOvenCleaningsectionforovencleaninginstructions.
Pour 8 ounces of water onto the
oven floor.
lean J
22
To Begin Steam Clean Cycle:
J71 Removeracks and accessoriesfrom the
oven cavity. Donot placecookware or
other items in the oven during the Steam
Cleancycle,
j-_ Pour i cup (8oz.)room-temperature water
onto the recessedarea of the oven bottom.
Do not add cleaning solutions or chemicals
of any kind to the water. Onlyadd water
when usingthe Steam Clean Cycle.Donot
add water when using the Self-CleanCycle
[-_ Closethe door. Formodels with a latch,
latch the door. Note: Never force the latch.
If the oven istoo hot, you will not be able to
slidethe latch. Allow the oven to cool.
[] Pressthe Steam Clean pad; then press
Start/On.
[] A 30-minute cycle will begin to count down
on the display.
@
D
ra]
When the Steam Clean cycle iscomplete,
the oven control will beep. Pressthe Clear/
Offpad and open the door.
The oven bottom and remaining water will
still be very warm at the end of the cycle.
This isnormal.
Removesoilsusing a scrub brush or nylon
scouring pad. A soap-filled steel wool pad
may be usedonly on the porcelain oven
interior.The useof abrasive pads will
scratch the door glass.Donot wipe soilor
water onto the door gasket.
[_] Removeany remaining water with a dry
cloth or sponge.
[] Leave the door open to air dry.
IMPORTANTNOTES:
If a steam clean cycle is initiated without
water, pressthe Clear/Offpad to end the
cycle.Wait for the range to cool to room
temperature before pouring water into the
recessedarea and initiating another steam
cycle.
Donot open the door during the Steam
Cleancycle.An error beep will sound upon
opening the door.
PressClear/Offpad at any time to end the
cycle.
If mineral deposits remain in the oven
bottom after cleaning, use a cloth or sponge
soaked in vinegar to remove them.
Somewater may drip from the bottom of
the oven door. Ifthis happens, wipe it up at
the end of the cycle.
Thedoor gasket may bewet when the
Steam Clean cycle finishes.This is normal.
Donot cleanthe gasket.
If soilstill remains after cleaning the oven,
seethe Care and cleaning of the range
sectionof the Owner's Manual for additional
options.

Related product manuals