Revision C 170 Series Monitor 4-13
2000947-004
Setup Procedures: Customizing the Monitor
NOTE: If you press the
Power button to exit the setup mode (user or service)
any changes you made will not be stored in memory.
NOTE: You must exit by pressing the
Setup button in order for changes to
take effect.
NOTE: If an alarm is in progress when you exit the user setup mode, any changes
to an alarm setting do not take effect until the alarm condition is resolved.
Table 4-2 lists the available settings for the user setup mode. Table 4-3 lists the
available settings for the service setup mode. Table 4-4 provides a summary of the
factory default settings for both the user and service setup options.
To Next Page
Loading...
Need help?
General
