GE CT-9800 - Page 200

GE MEDICAL SYSTEMS CT 9800 QUICK SYSTEM
Rev. 1 Direction 18000
6-3-2
3-3 Mag Tape Adjustments (Continued)
2. At the prompt (==>), observe the following, and type the underlined responses:
==> LOAD 6026 RELI ’CR’
LOAD:
6026 RELI REV. nn
DUAL MODE TAPE RELIABILITY REV. nn
MAX DATA BLOCK SIZE 37777
A. MOUNT SCRATCH TAPE
B. SET SWPAK AS PER 8.0
C. HIT ”CR” KEY TO CONTINUE
3. At the S/140 front console, hold the UNLOCK switch and press RESET. Observe the Virtual Console
prompt (!) on the screen.
4. Restart the program at address 505 by typing the underlined:
!505R
COMMAND STRING TEST
MAX DATA BLOCK SIZE 37777
UNIT
5. The command string is now loaded and ready to operate as directed in later procedures.
6. The following information may be useful when using the command strings:
a. When the execution of a command string is complete, the program will return to the “UNIT”
prompt.
b. If you want to repeat a command string without changing anything, type ‘CR’ in response to each
question.
c. A command string may be stopped during execution by hitting the ESC (escape key). The
program then returns to the “DATA” question.
d. Change tape modes only when the tape is at BOT. If the mode is changed when the tape is not
at BOT, it will rewind to BOT and reset the drive.
e. Use only the space forward, space backward, and read commands with the Master Skew Tape.
Never REWIND or WRITE with the skew tape.