GE CT-9800

GE MEDICAL SYSTEMS CT9800 QUICK SYSTEM
Rev. 14 Direction 18000
4-3-41
INITIALIZER PROGRAM
The Initializer program is used to initialize the controller and disk drive(s) as well as load ACE microcode. The
Disk Initializer program has four modules.
1) ZDKINIT (does all also)
2) ANALYZE DISK.
3) RELOCATE BLOCKS
4) MICROCODE INSTALL ONLY.
ZDKINIT should normally be used as follows:
The following example is for a CT Single or Dual Ace system only:
File# Program
2 GESCSI CONFIGURATOR
3 GESCSI FORMATTER
4 GESCSI INITIALIZER
5 MV7800 MICROCODE LOADER REV. 3
File Number? 4<CR>
>>>>
GESCSI Disk Initializer
Rev. 4.00
Copyright 1987, Zetaco Inc.
Command List
____________
[E]nter a device [D]elete a device
[S]tart a device [H]alt a device
[R]estart the program [L]ist device status
[C]ommand list [P]rinter control
[F]lags [M]ode of display
[X]eq and error log [Q]uit
Enter a Command Selection (C=Cmd List): E<CR>Enter the device code [24]: <CR>
Start initialization of controller.
Micro-code rev #: 3.00
End initialization of controller.
Unit 0. is Ready; Select (YES,[NO]): YES<CR>
Note: Use [Z] without selecting any units to
initialize the controller only.
Command choices:
[Z]DKINIT (ZDKINIT, INSTALL MICROCODE, INIT SOFT LOG)
[A]NALYZE DISK
[R]ELOCATE BLOCKS
[M]ICROCODE INSTALL ONLY
ENTER YOUR SELECTION [Z]: <CR>
UNIT 0. IS SELECTED Note: If other units are ready, do not select them for ZDKINIT.
UNIT 1. IS NOT READY
UNIT 2. IS NOT READY
UNIT 3. IS NOT READY
**** Note **** You must enter [S]tart in order to have the selected operation actually take place.
Enter a Command Selection (C=Cmd List): S<CR>
Start all entered devices ([YES] NO): <CR>
Enter a Command Selection (C=Cmd List):
RUN TIME 0. HRS. 0 MINS. 3. SECS. 0. tenths
DEVICE CODE 24 UNIT NUMBER 0. DEVICE STATE: ** ACTIVE**
MODES: - INSTL MICROCODE - ZDKINIT THIS UNIT IS COMPLETE WITH ITS ASSIGNED TASKS.
Enter a Command Selection (C=Cmd List): Q<CR>
The disk is now initialized and the microcode is loaded.