GE CT-9800

GE MEDICAL SYSTEMS CT9800 QUICK SYSTEM
Rev. 14 Direction 18000
4-3-51
1 ACE Drive example:
Enter a Command Selection (C=Cmd List): L<CR>
Run time 0.hrs. 14.mins. 18.secs. 0.tenths.
Device Code 24 SCSI dev. number 0. Unit number 0. State: Active
Modes - FORMAT - ANALYZE
Formatting complete # of blocks analyzed 0.
# of Hard errors reported 0. # of Soft errors reported 0.
BAD BLOCK LOG
END OF BLOCK LOG
Enter a Command Selection (C-Cmd List): When Analyze is finished the following appears:
Run time 1.hrs. 39.mins. 6.secs. 2.tenths.
Device Code 24 SCSI dev. number 0. Unit number 0. State: Active
Modes - FORMAT - ANALYZE
This unit is complete with it’s assigned tasks.
Enter a Command Selection (C-Cmd List): L<CR> ENTER L for list
Run time 1.hrs. 39.mins. 10.secs. 9.tenths.
Device Code 24 SCSI dev. number 0. Unit number 0. State: Halted
Modes - FORMAT - ANALYZE
Formatting complete # of blocks analyzed 586764.
# of Hard errors reported 0. # of Soft errors reported 0.
BAD BLOCK LOG
END OF BLOCK LOG
Enter of Command Selection (C-Cmd List): Q<CR>
2 ACE Drive example of Format only (Analyze same as above except twice as long):
Enter a Command Selection (C=Cmd List): L<CR>
Run time 0.hrs. 14.mins. 4.secs. 4.tenths.
Device Code 24 SCSI dev. number 0. Unit number 0. State: Active
Modes - FORMAT
Formatting waiting to be started # of blocks analyzed 0.
# of Hard errors reported 0. # of Soft errors reported 0.
Device Code 24 SCSI dev. number 1. Unit number 0. State: Active
Modes - FORMAT
Formatting in process # of blocks analyzed 0.
# of Hard errors reported 0. # of Soft errors reported 0.
Enter of Command Selection (C-Cmd List): L<CR>
Run time 0.hrs. 14.mins. 18.secs. 2.tenths.
Device Code 24 SCSI dev. number 0. Unit number 0. State: Active
Modes - FORMAT
Formatting in process # of blocks analyzed 0.
# of Hard errors reported 0. # of Soft errors reported 0.
Device Code 24 SCSI dev. number 1. Unit number 0. State: Halted
Modes - FORMAT
Formatting complete # of blocks analyzed 0.
# of Hard errors reported 0. # of Soft errors reported 0.
Enter of Command Selection (C-Cmd List): L<CR>
Run time 0.hrs. 29.mins. 15.secs. 2.tenths.
Device Code 24 SCSI dev. number 0. Unit number 0. State: Halted
Modes - FORMAT
Formatting complete # of blocks analyzed 0.
# of Hard errors reported 0. # of Soft errors reported 0.
Device Code 24 SCSI dev. number 1. Unit number 0. State: Halted
Modes - FORMAT
Formatting complete # of blocks analyzed 0.
# of Hard errors reported 0. # of Soft errors reported 0.
Enter of Command Selection (C-Cmd List): Q<CR>