GE Energy
D20/D200
Installation and Operations Guide
General 994-0078-2.00-7
Full
107
D20/D200 Software Configuration, continued
Procedure (continued)
Step Action
15
Type el /p to display the error log.
Result:
The D20MES> prompt should return, indicating no errors
found.
Errors?
Record error(s), and re-try download.
If errors persist, contact GE Energy for support.
16
Type el /r to ensure that log is clear.
17
Type Boot to restart device.
Result: Code
File Load
Completed
The flash memory of the D20ME now has a fully operational code, or firmware, file
loaded.
Configuration
File Download
While the D20ME is running on the BootROM, you will be prompted to log in to the
68K Monitor, where standard Config Pro procedures can then be used to download
a configuration file.
Multi-Node
Downloads
D20ME VME modules can be used in a multi-node VME system D20 or D200.
The application code for each D20ME module in a multi-node system can be either
the same, or different for one or more of the modules.
You must repeat the download procedure for each of the nodes in a multi-node
system.
Note:
Do not re-start (Boot) the multi-node system until the code files for all
D20ME cards have been downloaded.
To Next Page
Loading...
