GE Energy
D20/D200
Installation and Operations Guide
General 994-0078-2.00-7
Full
91
Power-up and Test, continued
Procedure: Set
up Terminal
Steps to set up a PC to act as a WESMAINT II+ terminal.
Step Action
1
Open the VT100 compatible terminal emulation software you are going
to use.
2
Verify (or set) terminal communications settings as follows:
Data Rate 9600 bps
Data Bits 8
Stop Bits 1
Parity Non
Flow Control Xon/Xoff (software)
Connector Settings COM1 or COM2, as
required by the computer
you are using
Results: Your terminal emulator settings are now configured.
To Next Page
Loading...
