GE Grid Solutions
GE Information 994-0081-3.00-21
Downloading a Configuration, Continued
Procedure: Download Files (continued)
Step Action
11 Type Y and press ENTER at the Do you wish to proceed? prompt
(not case-sensitive)
Result: The system automatically verifies that Flash EPROM
memory has been cleared.
The D25S> prompt appears. The download can be
started.
Optional Step 1: Speed-up communication to shorten download time.
• Changing the speed to a higher rate may increase the probability of a
communication error, resulting in failure of the download procedure.
• Some third-party communication applications may not be capable of
running at these higher speeds reliably.
If you experience either of these limitations, leave the communication
speed at the default value of 9600 bps.
12 Type Baud 38400 ENTER (speeds up to 38.4 Kbps, may be chosen
based on ambient EMI, cable length, PC and software limits etc.)
Result: the monitor will now be communicating at 38.4 Kbps
13 Configure the HyperTerminal program to communicate at the
same speed, and reconnect to the 68K monitor.
Optional Step 2: Provide feedback during download
14 If the communication software you are using does not have any
“progress indicator’, such as HyperTerminal, echo can be
enabled to visually display the code file on your monitor as it is
transferred.
This option can be usually found in the communication settings or
properties of the communication program.
Note: enabling echo may slow transfer slightly.
To Next Page
Loading...
Need help?
General
