GE D30

D30 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL 5-1
D30 Line Distance Protection System
Chapter 5: Settings
Settings
This chapter outlines front panel and/or software settings. The relay is not taken out of service when saving settings; the
relay is taken out of service when a settings file is written to it.
Settings can be viewed remotely in a web browser by entering the IP address of the relay, accessing the Device
Information Menu option, then the Front-Panel Display Report option.
When indicated that a restart is required for a setting change to take effect, use the Maintenance > Reboot Relay
Command in the software.
Settings file conversion from previous firmware versions is supported. See the Maintenance chapter.
5.1 Settings menu
 SETTINGS
 PRODUCT SETUP

 SECURITY

See page 5-7

 DISPLAY
 PROPERTIES
See page 5-25

GRAPHICAL FRONT PANEL Access in EnerVista
See page 5-27

 CLEAR RELAY
 RECORDS
See page 5-39

 COMMUNICATIONS

See page 5-40

 MODBUS USER MAP

See page 5-107

 REAL TIME
 CLOCK
See page 5-107

 FAULT REPORTS

See page 5-112

 OSCILLOGRAPHY

See page 5-114