DigitalFlow™ GF868 Startup Guide (1 and 2-Channel) 33
Chapter 3. Operation
Chapter 3. Operation
3.1 Introduction
See Chapter 1, Installation, and Chapter 2, Initial Setup, to prepare the system for operation. When the meter is ready
to take measurements, proceed with this chapter. The following specific topics are discussed:
• Powering Up
• Using the Display
• Taking Measurements
Note: All inputs and outputs of the Model GF868 are calibrated at the factory, prior to shipment. If it becomes
necessary to recalibrate any of the inputs and/or outputs, see Chapter 1, Calibration, of the Service Manual.
WARNING! To ensure the safe operation of the Model GF868, it must be installed and operated
as described in this manual. In addition, be sure to follow all applicable local safety codes and
regulations for the installation of electrical equipment.
To Next Page
Loading...
Need help?
General
