Chapter 1. Programming Site Data
36 DigitalFlow™ GF868 Programming Manual (1-Channel)
1.15.1 Procedure Options
After completing the above steps, the meter returns to the User Program prompt. Continue as follows:
• To continue programming the meter, refer to the menu maps in Appendix A and navigate to the desired menu.
Then, proceed to the appropriate section of this manual for instructions.
• To leave the User Program and retain the previous settings, press [EXIT] and then press [F1] = NO at the SAVE
prompt. Any programming changes will be discarded and you will be returned to the data display.
• To leave the User Program and return to measurement mode, press [EXIT] and then press [F2] = YES at the SAVE
prompt. Your programming changes will be entered into the meter’s memory, and you will be returned to the data
display.
To Next Page
Loading...
Need help?
General
