GE Druck PC6-IDOS - Menu 2: Setting Menu Functions; Alarm Settings; V;mA Measure Settings; V;mA Source Settings

6Page
Continued on
Page 7
}
FUNCTIONS (MENU 2)
SETTING MENU
Menu 2
- To set user specific functions. (Set Functions)
High
Low
Measure
Zero
FS
Text
Root
Source
Setup
Status
Root
Step
Ramp
Status
Rate
Dwell_time
Exit
Exit
Exit
Allow the user to set a High or Low Pressure Alarm Limit.
(by using the increase/decrease facility above which an alarm sounds.)
Voltage / Current input settings for Converted Measurement.
Set Zero.
Set Full scale value.
User defined measurement text.
Switch measurement root function ‘on’ or ‘off’.
Voltage / Current output settings.
Sets the parameters for voltage/current sourcing.
Switches output on or off.
Switch sourcing root function ‘on’ or ‘off’.
Set step value (%FS)
Settings for Ramp mode
Switches ramp mode on or off.
Sets the ramp rate (V or mA/Sec).
Sets the time for which the output remains at the same level.
Returns to Source sub-menu.
Returns to Source sub-menu.
Returns to Pressure Display.
V / mA
Exit
Range
Zero
FS
Exit
Convert
Zero
FS
Text
Exit
P to V / mA
Zero
FS
Exit
Exit
Reverts back to Pressure Display.
Sets the following values:-
Sets Zero value
Sets Full Scale value
Returns to Source sub-menu.
Sets the following converted values:-
Sets converted Zero values.
Sets converted Full Scale values.
User defined converted text.
Returns to Source sub-menu.
Sets Pressure to V / mA conversion factors.
Set zero values.
Set Full Scale values.
Returns to Source sub-menu.
K0354, Iss. 1