MENU
MENU
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
15Page
1.8 Units
1.9 Max., Min., Switch, Temp C, Date & Time, %
1.10 Tare
To change the units of pressure, proceed as follows:
• Press the key once, then press key to choose
the units sub-menu
• Select required unit by pressing the key and then press
key.
The display will indicate the pressure in the selected unit and the
pre-selected 2nd line function.
To display any one of these functions, proceed as follows:
• Press the key once and then scroll to the required
function using the or key and then press
key to select it.
The display will show the pressure on the top line and the 2nd line
will show the function that has now been selected.
°
For Max. & Min., the displayed values are based on a 60Hz update rate.
However, since the upper line pressure value is updated every half a second,
the Max./Min. values may not be seen here. Conversely, for switch, each time
the switch changes state, the upper line pressure value is refreshed with the
latest 60 Hz pressure value.
:
The Tare value can be displayed on the bottom line by selecting
‘Tare’ from the menu using the key and pressing the key.
To activate function: hold down the key for 4 seconds
while in the pressure display mode. The unit will bleep after two
seconds when the Max. and Min. values reset. At four seconds
another bleep will sound as the displayed pressure now resets to
zero. This is a temporary function and will be cancelled when the
unit is switched off.
Tare
1.11 V/mA (procedures are the same unless otherwise
stated)
Two main options are available for ‘V’ and ‘mA’:-
• Select ‘Measure’ for V and mA input.
• Select ‘Source’ for V and mA output.
To measure input voltage or current select ‘Measure’ and
press the key.
Two options are now available; ‘Actual’ and ‘Convert’.
• ‘Actual’ is selected by pressing the key.
An example display below shows the Measure Mode symbol
on the second line.
• Select ‘Convert’ using the key and press the
key. To setup the conversion parameters, i.e. zero, full
scale or text; see 2.1 on page 22.
K0354, Iss. 1
To Next Page
Loading...
