GE Druck PC6-IDOS - Menu 2: Additional Settings; V-out and Display Light Control; Resolution and Event Configuration

26Page
2.3 V-out, Display Light
2.4 Resolution
These functions may be selected as follows:
• Switch on PC6-IDOS.
• Press the key twice to select the Set menu.
• Select the required function using the keys
and then press the key. Each of these functions has
an On or Off setting.
• Select the setting using the key and then press the
key.
To change the resolution proceed as follows:
• Press the key twice to select the Set menu.
• Select 'Resolution' using the keys and
press the key.
• Select the required resolution ( Low, Normal or High )
using the keys and then press the key.
Resolution will change by a factor of 10.
Note: The display light can also be set On or Off by holding
down the key for 2 seconds. The display
light status is retained at power-off.
more than
Note:
2.5 Event
• Press the key twice to select the Set menu.
• Select 'Event' using the key and then press the
key. The Event menu is shown below:
This results in RS232 (status ON) output / data storage
triggered by key press.
• Select 'Key' using the key and then press the key.
This results in RS232 (status ON) output / data storage at fixed
time intervals set by the user.
• Select 'Timed' using the key and then press the
key.
• Select the digit to be modified using the key and
press the key. Use the keys to change the
value and press the key.
• Repeat for next digit and press the key.
• Change the time measurement units in the same way and
press the key.
• Press the key to return to the pressure display.
2.5.1 Key:
2.5.2 Timed:
MENU
ENTER
ZERO
ENTER
ZERO
MENU
MENU
ON/OFF
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
MENU
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
ENTER
ZERO
K0354, Iss. 1