GE Hot Lips Tube Sealer

3 Operation
3.4 How to load the tubing
26 HOT LIPS TUBE SEALER Operator Manual 87-4500-07 AI
3.4.6 Checking the version number
Press the Enter ( ) button and then press the Cursor down button to access the
status display. The unit will first initialize and then display the current program and
data revision and also the number of seals made. Press MENU to return to the
normal operations display.
The date code of the loaded version is shown on the status display. New tubing
data can be obtained from GE Healthcare and downloaded by the user. See the
Maintenance section of this manual.
3.4.7 Setting tube diameter units
Tube dimensions can be displayed in inches (default) or mm. Press MENU and Enter
buttons together to access the UNITS selection screen.
Press the Cursor up button to change the setting. Press the Enter button to accept
the new setting or MENU to abort.
# = 2 V=3 D=1105# = 2 V=3 D=1105
SEALS = 128 28°CSEALS = 128 28°C
Current tubing number
selected
Program version
Number of seals made
Tubing date version
Sealing jaw temperature
SET UNITS inch
Inches or mm
Current tubing
units
selected