GE Hot Lips Tube Sealer

HOT LIPS TUBE SEALER Operator Manual 87-4500-07 AI 9
Introduction 1
Safety precautions 1.3
Recycling
1.3 Safety precautions
All users must read this section and the Safety instructions chapter in STERILE
TUBE FUSER - DRY and HOT LIPS TUBE SEALER Operating Instructions before
using HOT LIPS TUBE SEALER, and observe the safety information at all times
during use.
This symbol indicates that the waste of electrical and electronic
equipment must not be disposed as unsorted municipal waste
and must be collected separately. Please contact an authorized
representative of the manufacturer for information concerning
the decommissioning of equipment.
WARNING
The end user must ensure that all installation, maintenance,
operation and inspection is carried out by qualified personnel who
are adequately trained, understand and adhere to local regulations
and the operating instructions, and have a thorough knowledge of
the entire system and process.
WARNING
Hot surfaces of HOT LIPS TUBE SEALER. The jaws reach over 200°C
during the heating cycle. Do not touch the jaws during operation.
WARNING
Pinch hazard when using HOT LIPS TUBE SEALER.
The jaws are moving
during clamping and calibration. Keep away from the jaws when
clamping tubes and during the calibration procedure.
WARNING
Before starting HOT LIPS TUBE SEALER please make sure that no objects/
tubes are kept in between the heating jaws or moving path.