GE Hot Lips Tube Sealer

HOt LIPS TUBE SEALER Operator Manual 87-4500-07 AI 29
Specifications 5
Technical specifications 5.1
5 Specifications
5.1 Technical specifications
Catalog Number
28-4117-04
Performance
Seals thermoplastic tubing with outer diameters from
6.4 mm (¼” ) to 31.8 mm (1¼” )
Typical sealing cycle takes 2 to 3 minutes
Compact and portable
Fully automated validatable performance
No accessories, compressed air or cooling water needed
Factory settings for sealing most thermoplastic tubing,
see Appendix A.
Dimensions
W × D × H: 165 mm × 356 mm × 203 mm (6.5” × 14” × 8”)
Weight
8 kg (18 lb)
Power
100-120/220-240 V~ auto-switching 6 Amp max.
Voltage
100-120/220-240 V~ ± 10%, autoswitch
Frequency
50 or 60 Hz
Maximum power
350 VA
Fuse
2 x T3.15AL, 250 V (5x20 mm)
Overvoltage
Category 2
Max. tubing OD
See Appendix A
Main. tubing OD
See Appendix A
Sealing cycle
2 to 3 minutes (includes heating up and cooling down)
Enclosure
Indoor use only
Pollution
Degree II
EMC
FCC Part 15 Subpart B Class A and EN61326-1
LVD
IEC/EN/UL61010-1 and CAN/CSA-C22.2 No.61010-1
Relative humidity
2% to 80% non-condensing