To Next Page

To Previous Page

Appendix C — Conﬁguring the RS-232 Interface Page 67

Computer

connections

In order to communicate with the Electronics Module, you need a

standard serial interface card installed in your computer. If your

computer has one serial card, it is addressed as COM1. If there is a

second serial card, it is addressed as COM2. You must also have a

cable with the following connectors:

• A 9-pin male D-sub connector for the Reference Port

• A 9-pin female D-sub connector for the computer (some com-

puters use a 25-pin connector, requiring an adaptor)

Questions and Answers:

Need help?

Do you have a question about the GE HumiLab and is the answer not in the manual?

GE HumiLab Specifications

General