iBox/iBox Kit
Installation and Maintenance Guide
GE Grid Solutions
994-0047-5.10-4 GE Information
Configuring Project Properties - LAN, continued
Procedure:
Configuring
Project
Properties -
LAN
[continued]
Step Action
3
Click the D2x > General tab.
4
On the General tab, select LAN Based Project.
5
Click the Segments tab.
On the LAN A tab, select LAN A Enabled, and enter the IP Address and
Subnet Mask.
Note: Even if your LAN has a default gateway, you do not need to enter
it here.
6
Click OK to save.
Next Step
The next step is:
• Configuring iBox Device Properties - LAN on page 101
To Next Page
Loading...
