GE Grid Solutions
iBox/iBox Kit
Installation and Maintenance Guide
GE Information
994-0047-5.10-4
Configuring the Ethernet Module, continued
Procedure:
Configuring
the Digi One
(continued)
Step Action
8
In Exceptions, add the default Digi One Ethernet IP address,
192.168.1.100.
Note: You can use the wildcard character (*) to specify a range of IP
addresses; for example, if you enter 192.168.*, all messages sent
to IP addresses starting with 192.168 will be sent directly, not
through the proxy server.
Note: Once you change the Digi One Ethernet IP address, you will have
to modify Proxy Settings accordingly.
9
Click OK and close all windows.
Changing Pass Through Switch Settings
10
Locate the pass-through switch on the bottom of the Digi One IAP
Change the switch setting from the default state OFF to ON
11
Reboot the Digi One IAP. Refer to steps 1 to 4 in Appendix C: Resetting
the Digi One Configuration.
Continued on next page
To Next Page
Loading...
Need help?
General
