IIinstallation ISelf-Cleanin DualFuel
nstructlons Slide-In Range J2S968,J2C968
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com
In Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca I
IN THE COMMONWEALTH OF
MASSACHUSETTS:
• This product must be installed by a
licensed plumber or gas fitter.
= When using ball-type gas shut-off valves,
they shall be the T-handle type.
= A flexible gas connector, when used, must
not exceed 3 feet.
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
• IMPORTANT - Savethese
instructions for local inspector's use.
• IMPORTANT - Observeall
governing codes and ordinances.
• Note to Installer - Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keep these
instructions for future reference.
• Product failure due to improper installation
is not covered under the Warranty.
AWARNING - This appliance must
be properly grounded.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
MATERIALS YOU MAY NEED
Joint Sealant Pipe Fittings Shut Off Valve
Lag Bolts Anchor Sleeves
(For Concrete Floors Only)
CSA-Approved Flexible Gas Line
3/8" Min. ID, 1/2" NPT Connection,
3-foot Maximum Length (Massachusetts only)
TOOLS YOU WILL NEED
1/4" Nut Driver
Phillips Head
Screwdriver
Tape Measure
Safety Glasses
Level
Pipe Wrench
Wrench or Pliers
(for 1-7/16" Nut)
Drill
PARTS INCLUDED
Screws
Anti-Tip Bracket
31-10626-1 (01-06 JR) 1
To Next Page
Need help?
General
