GE JBP22 - Control Panel and Knobs; Metal Parts; Oven Vent; Painted Surfaces

Control Panel and Knobs
Clean up any spills or spatters with a damp cloth.
Remove heavier soil
with warm, soapy water.
Clean the control panel with mild liquid dish detergent
and
a soft cloth. Rub the control panel lightly.
CAUTION: Do not use abrasives of any kind on
the control panel. The lettering on models with touch
pads is sensitive to abrasives and pressure.
——.—
The control knobs may be removed for easier cleaning.
To
remove a knob, pull it straight off the stem. Wash
the
knobs in soap and water but do not soak.
I
Metal Parts
Do not use steel wool, abrasives, ammonia or commercial oven
cleaners. To
safely clean surfaces: wash, rinse and then dry with a
soft cloth.
In
Glass Surfaces
To clean the outside glass finish, use a glass cleaner.
~~~
Rinse and polish with a dry cloth.
r J - :
w ‘1
I I
A +===========
Painted Surfaces
I
Painted sLIrfaccs include the outside oven door, sides, control panel
and drav’er front. Clean thew with soap and water or a ~inegar and water
solution. Do not use commercial oven cleaners, cleansing powders,
steel wool or harsh abrasives on any painted surface.
I
Oven Vent
The ok en is ~ented tht-ough an opening under the right rear surface unit.
Ne\Ier Lx)trer the opening with aluminum foil 01
-
any other material. This
woLl]d pre~renl the ol en k’ent from working properly.
(t olztitzu(d fIe.Yr p({,qf’)
27