General procedures
LOGIQ V3/V5/V5 Expert – Basic Service Manual 4-15
5726264-100 English Rev.8
4-2-7-3 Restore System Presets and Configurations
1. Insert the Backup/Restore CD/DVD (or USB memory
device) into the drive.
2. Enter enter Utility-> System-> Backup/Restore.
NOTE: If you are not logged in with administrator privileges, the
Operator Login window is displayed.Log on with
administrator privileges.
3. In the Restore list, select Patient Archive, Report Archive,
User Defined Configuration and Service.
4. In the Media field, select the Backup/Restore CD/DVD (or
USB memory device).
5. Select Restore.
The system performs the restore. As it proceeds, status
information is displayed on the Backup/Restore screen.
Figure 4-8. Restore message
The restore procedure overwrites the existing database on the
local hard drive. Make sure to insert the correct CD (or USB
memory device).
To Next Page
Loading...
