GE MAC 5000

5-20 MAC™ 5000 resting ECG analysis system Revision B
2024917-010
Troubleshooting: Frequently Asked Questions
Frequently Asked Questions
Maintenance
NOTE
See Operator’s Manual for complete System Setup information.
Save Setups
Q: How do I save changes I have made to the System Setups?
A: Check the following:
 Return to Menu by pressing the esc key or selecting More from
the menu until you see System Setup.
 Select System Setup.
 Select Save Setup.
 Select To System.
 You can select Main Menu to exit System Setup.
Storing ECGs
Q: Why won't any of the ECGs I perform save to the floppy diskette?
A: Check the following:
 Check that the diskette is fully inserted into the drive.
 Make sure you are using high-density (HD) 3.5" diskettes.
 Verify that the diskette is not write-protected.
 Try a new diskette.
 If your system is not set up to automatically save records, you
must manually save by pressing Store.
Format a Disk
Q: How do I format a diskette in the MAC 5000?
A: When you insert a new diskette into the MAC 5000 the system will
automatically format the diskette. If you are using a previously-used
diskette, and want to reformat it, you can format it at a PC.
Cleaning
Q: Should I clean the MAC 5000?
A: Clean the exterior surfaces of all the equipment and peripheral
devices monthly, or more frequently if needed.
 Use a clean, soft cloth and a mild dishwashing detergent diluted
in water.
 Wring the excess water from the cloth. Do NOT drip water or any
liquid on the writer assembly, and avoid contact with open vents,
plugs, and connectors.
 Dry the surfaces with a clean cloth or paper towel.