EasyManuals Logo

GE Mini Field Agent Instructions For Installation And Configuration

GE Mini Field Agent
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
For example, if the UTC timestamp is Wed June 7 9:13:54
2017, type date -s "2017-06-07 09:13:54".
hwclock --systohc
This command updates the hardware clock to local system
time.
2. To verify that the correct timestamp and timezone is set and to
check if the hardware clock is in sync with the local time, type
the following and then press Enter after each entry.
date
hwclock --show
Configuring Anesthesia Machine to Mini Field Agent
Perform the following procedure to configure the anesthesia machine
to communicate with the SBX Network Client. See Super User mode
in the Anesthesia Machine User's Reference Manual for further
details.
This configuration has to be performed on each anesthesia machine
that communicates to the Mini Field Agent.
1. Enter Super User mode on the anesthesia machine.
2.
Select System Config and then select Time Zone to view
the set time Zone.
Verify that the Time Zone set is based on the region where
anesthesia machine is installed. The Time Zone set on the
anesthesia machine for New York is shown for reference in the
below screenshot.
Note
Note
18 2094532-001 D 02 2018

Other manuals for GE Mini Field Agent

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Mini Field Agent and is the answer not in the manual?

GE Mini Field Agent Specifications

General IconGeneral
BrandGE
ModelMini Field Agent
CategoryComputer Hardware
LanguageEnglish

Related product manuals