3–18 MM200 MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
ENERVISTA MM200 SETUP SOFTWARE CHAPTER 3: CONTROL PANEL
3. Check the Setup Software for the availability of the USB Device on the Device setup
Window. It will automatically reappear on the ‘USB Device’ list as ‘MM300/MM200 USB
Serial Emulation (COM #)’ as shown in the image below.
4. If the USB Device is not recognized automatically in the Setup Software, repeat the
same procedure 2 or 3 times until the PC Program recognizes the USB device (and
‘MM300/MM200 USB Serial Emulation (COM #)’ reappears in dropdown of ‘USB Device’
list).
5. If problem still persists, uninstall the USB driver from Computer’s ‘Device Manager’
under tree-branch modems from the Installation folder. To uninstall it, right click on
MM300/MM200 USB Serial Emulation and select Uninstall.
6. After the uninstall, remove the USB cable from the Device’s native USB port, wait for at
least 10 Seconds and reconnect it.
To Next Page
Loading...
