April 2004
4-4 Programming with PanaView
Change Meter
Programming
1. To change a particular window, click on it. The selected window
turns red.
2. Click on the desired meter on the network tree to the left of the
programming window. A list of available channels appears. Click
on the channel you wish to apply.
3. The tree expands to show a list of available sensors.
a. Click on the desired sensor, and the tree expands further to
show a list of available units.
b. Double-click on the unit, and the Series 1 reassigns the selected
box, on the Series 1 and in the “Meter Display” window.
c. To unassign a mode and unit without assigning a different
sensor, click on the desired window and then on [
Unassign].
Figure 4-2 on page 4-5 shows a typical change on the PC screen from
O2/ppm (shown in Figure 4-1 on page 4-3) to PSIg.
Note: For an explanation of unit abbreviations, see Table 2-6 on
page 2-31, “Measurement Modes and Units for the Series 1.”
4. Click [
Apply] to apply the change immediately and continue
programming, and [
OK] to confirm the change and close the
window.
Note: To return the window to its previous settings, click on the
[
Cancel] button instead of the [OK] button.
To Next Page
Loading...
