GE Moisture Image 1 Series - Changing a Matrix Display to a Graph

April 2004
4-6 Programming with PanaView
Changing a Matrix
Display to a Graph
To set a graph display of a single mode and unit:
1. Click on the [
Graph Display] button. The window changes to list
the graph parameters.
2. Click on the meter icon to show lists of the available modes and
units.
3. Double-click on the desired unit, and enter the parameters for the
graph, as shown in Figure 4-3 below.
4. Click on [
Apply] to change the graph, and on [OK] to confirm the
change and close the window.
5. Click on the [
Set Active Display] button to prompt the Series 1
screen to display the graph.
To toggle between the matrix display and the graph, click on the
[
Matrix Display] or [Graph Display] buttons. The window returns to
the display indicated.
Figure 4-3: Graph Programming Window