Basic Programming 2-9
April 2004
Activating and Changing
Probes
Although the probes are physically connected to the back of the
electronics unit, you must “tell” the electronics what type of
measurements the probe is capable of making. In addition, if you
want to use a constant value rather than a live input, you must “tell”
the electronics that you are using a constant value.
If you do not activate probes, or if you activate them incorrectly, the
unit will display
No Probe or other error messages.
Once you verify and/or change configuration data, refer to Entering
Calibration Data on page 2-12.
Verifying Probe
Configuration Data
IMPORTANT: You should record this data on the Program
Information List supplied in Appendix A of the
Startup Guide, or on a separate sheet of paper, and
keep it in a safe place.
1. Enter the Probe Configuration Menu (for a menu map, refer to
Figure 3-19 on page 3-32). A screen similar to Figure 2-5 below
appears.
* The Settings Menu will prompt for a passcode (see page 2-6).
Figure 2-5: Probe Configuration Menu
Table 2-1: Entering the Probe Configuration Menu
Press the Main Menu key: To enter the:
SETTINGS* Settings Menu
SYSTEM System Settings Menu
CONFIG Probe Configuration Menu
Ch O2 HYG T P Aux1 Aux2
SYSTEM CONFIGURATION
1
2
3
4
5
6
Probe Configuration Menu
HELP TAG ERRORS DONE
To Next Page
Loading...
