GE Moisture Image 1 Series - Setting the Range for Recorders

Advanced Programming 3-3
June 2003
Setting the Range for
Recorders
Figure 3-19 on page 3-32 for a menu map.
1. At the Recorder Settings Menu (see Table 3-1 on page 3-1), press
the SET menu key. The menu keys change to [RANGE], [MODE]
and [A
 B].
2. Press the RANGE menu key. A list of the available output ranges
appears on the message line.
3. Move the brackets to the desired output range and press [YES].
4. With the arrow key, move the pointer to the Zero line for the
desired recorder. Press [YES] to erase the present value.
5. Enter a new value and press [YES].
6. Move the pointer to Span for the desired recorder and press [YES]
to erase the current value.
7. Enter a new value and press [YES].
8. Repeat steps 1 through 6 to set up the other recorder.
Repeat all of the above steps to set up recorders for the desired
channels.
To exit, press the DONE menu key until Main Menu appears in the
message line.