GE Moisture Image 1 Series - Page 50

Basic Programming 2-31
April 2004
Table 2-6: Measurement Modes and Units for the Series 1
Selected
Meas. Mode Description of Units
Displayed
Meas. Mode
Displayed
Units
Oxygen
O
2
%= Percent Oxygen default Oxygen %
O
2
/ppM = Parts Per Million Oxygen ppm
v
O
2
/ppB = Parts Per Billion Oxygen ppb
v
O
2
/µA = Microamps (Diagnostic Mode) Oxygen µA
O
2
/DVM = Digital Voltmeter (Diagnostic Mode) Oxygen DVM VDC
Hygrometry
DP/°C = Dew/Frost Point default Dew Point °C
DP/°F = Dew/Frost Point °F Dew Point °F
DP/K = Dew/Frost Point K (Kelvin) Dew Point K
%R.H. = Relative Humidity Rel. Humidity %
H/ppMv = Parts per Million of Water by Volume H
2
Oppm
v
H/ppMw = Parts per Million of Water by Weight (for liquids only) H
2
Oppm
w
H/ppBv = Parts per Billion of Water by Volume H
2
Oppb
v
MCF/IG = Pounds of Water per Million Std. Cubic Feet in Ideal Gas H
2
O/MMSCF NG lbs
MCF/NG = Pounds of Water per Million Std. Cubic Feet in Natural Gas H
2
O/MMSCF NG lbs
ppMv/NG = Parts Per Million by Volume in Natural Gas H
2
O (Nat. Gas) ppm
v
mmHg = Vapor Pressure Vapor Pressure mmHg
Pas = Vapor Pressure Vapor Pressure Pas
MH = MH* (Diagnostic Mode) H
2
OMH
H/DVM = Digital Voltmeter (Diagnostic Mode) Moisture DVM VDC
FH = FH* (Diagnostic Mode) MIS Probe FH
Temperature
T/°C = Degrees Celsius default Temperature °C
T/°F = Degrees Fahrenheit Temperature °F
T/K = Kelvin Temperature K
T/DVM = Digital Voltmeter (Diagnostic Mode) Temp DVM VDC
Pressure
PSIg = Pounds per Square Inch Gauge default Pressure PSIg
Bars = Bars Pressure Bars
mbs = Millibars Pressure mbs
mm/Hg = Millimeters of Mercury Pressure mmHg
Pa(g) = Pascal, gauge Pressure Pas
kPas(g) = KiloPascal, gauge Pressure kPas
P/mV = Pressure in millivolts Pressure mV
P/DVM = Digital Voltmeter (Diagnostic Mode) Pressure DVM VDC
FP = FP** (Diagnostic Mode) MIS Probe FP
Auxiliary 1
Aux1/V = Volts default Aux1 VDC
Aux1/I = Milliamps Aux1 mA
Aux1/User = Function (Displays Aux Label) Aux1 (Aux Label) none
Auxiliary 2
Aux2/V = Volts default AuxX VDC
Aux2/I = Milliamps Aux2 mA
Aux2/User = Function (Displays Aux Label) Aux2 (Aux Label) none
Volt Reference Vref = Volts default (Diagnostic Mode)
Voltage Reference
VDC
Signal Ground
User
Vgnd = Volts default (Diagnostic Mode) Signal Ground VDC
*The MH and FH values are the moisture sensors’ response values and are the values that are recorded during calibration.
**The FP value is the MIS Probe’s response value for pressure and is the value recorded during calibration.