Advanced Programming 3-27
June 2003
Note: In the formats presented above, the plus/minus (±) symbol
indicates that the data is signed and will be preceded by a plus
(+) or minus (-) sign.
The number of decimal places indicated is for nominal values.
The instrument will maintain the number of digits by
“floating” the decimal point to the right as the magnitude of
the number increases. DO NOT “hard-code” the decimal
points when using data acquisition software.
Pressure (Continued)
kPas XXX.XX Pressure in kiloPascals absolute.
P/mV ±XXX.XX Pressure transducer output in millivolts.
FP XXXX.XX GE Panametrics pressure calibration unit in
millivolts.
P/DVM X.XXXX Pressure circuit voltage in volts DC.
Auxiliary Inputs
Aux1/V ±X.XXXX Auxiliary input #1 in volts.
Aux1/I ±XX.XXX Auxiliary input #1 in milliamperes.
Aux1/F ±XX.XXXX Auxiliary input #1 in user-defined units.
Aux2/V ±X.XXXX Auxiliary input #2 in volts.
Aux2/I ±XX.XXX Auxiliary input #2 in milliamperes.
Aux/F ±XX.XXXX Auxiliary input #2 in user-defined units.
Other
Vref ±X.XXXX Channel card reference voltage.
Vgnd ±X.XXXX Channel card ground voltage.
Table 3-9: Print-Out Symbols and Abbreviations (cont.)
Mode/Unit
Number
Format Measurement Mode
To Next Page
Loading...
