GE MultiLink ML1600 User Manual

CHAPTER 17: MISCELLANEOUS COMMANDS MISCELLANEOUS COMMANDS
MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 17–21
• clear-stats
•
portaccess
•
reauth
•
setport
•
show-port
•
show-stats
•
trigger-reauth
The device commands are shown below.
•
device
•
backpressure
•
broadcast-protect: enables or disables broadcast storm protection globally
•
flowcontrol
•
rate-threshold: sets the broadcast rate threshold (frames/sec)
•
setage: sets the mgtagetime
•
setport: sets the port configuration
The VLAN registration over GARP (GVRP) commands are shown below. Refer to VLAN
Registration over GARP on page 11–1 for details.
•
gvrp
•
help gvrp: configures GVRP parameters for dynamic VLAN
•
set-forbid: sets forbidden ports for a tag-based VLAN
•
show-ports: show ports current GVRP state
•
show-forbid: show forbidden ports for tag-based VLAN
•
set-ports: set GVRP port state usage
•
show-vlan: shows dynamic/static tag-based VLANs
•
static: convert dynamic VLAN to static VLAN
The IGMP commands are shown below. Refer to IGMP on page 15–1 for additional details.
•
mcast
•
set-leave: enables or disables IGMP immediate leave status
•
set-port: sets the port mode
•
set-qi: sets the query interval (60 to 127) for router ports
•
set-qri
•
set-querier: enables or disables switch as querier
•
show-group: displays IGMP group list
•
show-port: displays IGMP port mode
•
show-router: displays IGMP router list
The Link Aggregation Control Protocol (LACP) commands are shown below.
•
lacp
•
add port
•
del port
•
edit port

GE MultiLink ML1600 Specifications

General

Brand	GE
Model	MultiLink ML1600
Category	Switch
Language	English