5–28 MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
IP ADDRESSING CHAPTER 5: IP ADDRESSING
It is recommended to save the configuration (using saveconf command discussed above)
before using the kill config command. The following two examples illustrate how to erase
all the Switch’s configuration using the kill config command and the second example
illustrates how to erase all the Switch’s configuration with the exception of ‘system’
configuration.
ML2400# kill config
Do you want to erase the configuration?
['Y' or 'N'] Y
Successfully erased configuration...Please reboot.
ML2400# kill config save=system
Do you want to erase the configuration?
['Y' or 'N'] Y
Successfully erased configuration...Please reboot.
Once the configuration is erased, please reboot the switch for the changes to take effect.
To Next Page
Loading...
Need help?
General
