GE N60 - Page 628

H-2 N60 Network Stability and Synchrophasor Measurement System GE Multilin
H.1 CHANGE NOTES APPENDIX H
H
5-31 5-31 Add Added Far-End Fault Indication (FEFI) section
B- B- Update Updated Modbus memory map and F codes
H-7 H-7 Update Updated product warranty from 24 months to 10 years
Table H–2: MAJOR UPDATES FOR N60 MANUAL REVISION AA1
PAGE
(Z1)
PAGE
(AA1)
CHANGE DESCRIPTION
--- --- Add Added content for IEC 60870-5-103 throughout document
2- 2- Update Updated order codes
2- 2- Update Updated specifications
5-105 5-105 Update Updated hysteresis numbers and logic diagrams in section 5.4.6 Phasor Measurement Unit
7-11 7-11 Add Added AGGR CONFIG MISMATCH self-test error message
8- --- Delete Deleted chapter 8 on security, moving content to other chapters
--- 9- Add Added Maintenance chapter, moving content from other chapters and adding new instructions to
replace the battery
--- D- Add Added new appendix on IEC 60870-5-103 interoperability
Table H–3: MAJOR UPDATES FOR N60 MANUAL REVISION Z1
PAGE
(Y3)
PAGE
(Z1)
CHANGE DESCRIPTION
--- --- Add Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal View
figure in chapter 3, and CPU Module Communications Wiring figure in chapter 3
--- --- Add Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
1-1 1-1 Add Added General Cautions and Warnings to section 1.1.1
1-5 1-5 Update Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
2-6 2-6 Update Updated several specifications
5-24 5-24 Add Added section 5.2.5e Routing
5-86 5-86 Update Updated Figures 5-25 and 5-26 Dual Breaker Control Scheme Logic, sheets 1 and 2
5-90 5-90 Update Updated Figure 5-27 Disconnect Switch Scheme Logic
5-202 5-202 Add Reinserted section 5.8.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
Table H–4: MAJOR UPDATES FOR N60 MANUAL REVISION Y3
PAGE
(Y2)
PAGE
(Y3)
CHANGE DESCRIPTION
-- ix Add Added battery disposal information as chapter 0
Table H–5: MAJOR UPDATES FOR N60 MANUAL REVISION Y2 (Sheet 1 of 2)
PAGE
(Y1)
PAGE
(Y2)
CHANGE DESCRIPTION
All All Update Minor changes throughout document
Table H–1: MAJOR UPDATES FOR N60 MANUAL REVISION AA2 (Sheet 2 of 2)
PAGE
(AA1)
PAGE
(AA2)
CHANGE DESCRIPTION