GE NetworX Series - 7 I. Light Control for X-10 Devices; 7 J. House Codes for X-10 Devices; 7 K. Change Languages

NX-148E LCD Code Pad Installation and Setup Manual 15
7i. Light Control for X-10 Devices
When used in conjunction with an X-10 output device such as the NetworX NX-507E, NX-508E, NX-534E
or NX-540E, this menu allows the user to control up to ten X-10 devices from each code pad.
Action Result
  
      
Prompts to ‘Select Light Number 0-9’.
 [device number]
      
Displays the light number on the left.
Prompts to turn the light ‘On’ or ‘Off’ on the right.
  to turn ON
 
to turn OFF
      
Prompts to ‘Select Light Number 0-9’.
Repeat steps 2 and 3 until all devices have been
programmed.
 #
      
Exits the function.
7j. House Codes for X-10 Devices
When used in conjunction with an X-10 output device such as the NetworX NX-507E, NX-508E, NX-534E
or NX-540E, this menu allows the installer to program the specific X-10 unit and house codes for the ten
X-10 devices for this code pad.
Action Result
  
      
Prompts to ‘Please Enter Your Code’.
 [program code]
      
Displays light number and unit code.
 [X-10 unit code] 
      
Prompts for the unit code of the device.
 [X-10 house code] 
      
Prompts for the house code of the device.
Repeat 3
rd
and 4
th
steps until all devices have been
programmed.
 #
      
Exits the function.
7k. Change Languages
Action Result
  
      
Code pad toggles to the second language.
  
      
Code pad reverts to the first language.