NX-148E LCD Code Pad Installation and Setup Manual 9
2) The messages (custom, zone, and shutdown) are transferred to other LCD code pads after this
mode is exited. All code pads must be addressed and enrolled for this to happen.
3) Use the
function to set the code pad numbers prior to programming custom messages.
4) If a code pad is added after messages are programmed, you should either program all
messages in
it, or enter custom message programming on an existing code pad and make changes. This is to
prevent accidentally overwriting existing messages. Refer to
option to prevent overwriting
the custom message only.
Action Result
Prompts to ‘Please Enter Your Code’.
[program code]
The LCD will now prompt you to enter message
number followed by
#.
Zones 1 through 192 custom messages are
message numbers 1-192 respectively.
For example: For zone 1 description will read press
#, for zone 6 press #.
Message 193 - Custom message top line.
Message 194 - Custom message bottom line.
Message 195 - Shutdown message top line.
Message 196 - Shutdown message bottom line.
[message number] #
The LCD will display the zone number on the top
line and the description will be on the bottom line.
Use the instructions on page 5 for editing
character data.
Exit
Any changes will automatically be copied to all
other LCD code pads in the system.
If you desire an LCD code pad to have a
different custom message, you must enable
Custom Message Lock under the
function (page 10)
6d. Custom Messages in Language 2
Exit mode prior to changing languages.
Action Result
Code pad is now toggled to the second language.
Proceed with steps for usual programming.
To Next Page
Loading...
