GE NetworX Series - System Notes and Service Information

NX-148E LCD Code Pad Installation and Setup Manual
16
7l. Changing User Codes
 For systems with areas - someone changing the code of another person must have access to all or
more areas than the user being changed.
Action Result
  
      
Prompts ‘Please Enter Your Code’.
 [master code]
      
Prompts for a user number.
 [user code]
      
Prompts for a new code.
2-digit ID if NX-4, NX-8, NX-12, NX-16
3-digit ID if NX16 (use leading zeros!! i.e.  for
user 7)
 [new user code]
      
Prompts for a user number. Repeat 3
rd
and 4
th
steps if another user code needs to be
programmed.
 Code pad will beep 3 times if code is rejected.
 # while display is prompting
for a user number.
      
Exits and saves data.
7m. Assigning Authority Level
 You must have authority to the area you wish to add or remove from another person’s authority.
Action Result
  
      
Prompts ‘Please Enter Your Code’.
 [master code]
      
Prompts for a user number.
 [user code]
      
Prompts through the following list of attributes.
2-digit ID if NX-4, NX-8, NX-12, NX-16
3-digit ID if NX16 (use leading zeros!! (i.e. 
for user 7)
Outputs used?
If NO… If YES…
Master code? Output 4 enable?
Sched arm only? Output 3 enable?
Arm only? Output 2 enable?
Reserved Output 1 enable?
Open / Close Rprt?
Bypass enable?
Arm / Disarm?