NX-8E CONTROL
44
LOCATION 212 - PROGRAMMING THE LCD KEYPAD ADDRESS (1 segment of numerical data)
Certain commands in the NX-8E require it to know the location of at least 1 LCD keypad (if one exists in the system). If
your system has an LCD keypad it is recommended that it be placed in partition 1 keypad 1. This will allow location
212 to be left at the factory default. If the LCD keypad is selected as something other than partition 1/ keypad 1
program the appropriate address in location 212. Select the address from the following chart.
KEYPAD
PART 1 PART 2 PART 3 PART 4 PART 5 PART 6 PART 7 PART 8
1 192 193 194 195 196 197 198 199
2 200 201 202 203 204 205 206 207
3 208 209 210 211 212 213 214 215
4 216 217 218 219 220 221 222 223
5 224 225 226 227 228 229 230 231
6 232 233 234 235 236 237 238 239
7 240 241 242 243 244 245 246 247
8 248 249 250 251 252 253 254 255
To Next Page
Loading...
