3.4.3.2 Rails for Ergo suspension
The stationary rails are with fixed length of 3.3 m (10’10’’). The margin between the first hole of
the rail and the beginning of the rail is 50.8 mm (2").
Illustration 2-67: SPECIFICATIONS FOR STATIONARY RAIL MOUNTING INTERFACE
(BOTH RAILS CEILING MOUNTED), FOR ERGO SUSPENSION
3.4.4 Cable Support for Monitor Cables
A cable support (cable drape) is provided with a LC System.
The cable support kit contains:
•
1 B2054 EK (Drape with 3 M Bridge, on suspensions for X-Ray tubes and monitors,
contains 8 FT 6 inch track, three carriers, and mounting hardware)
•
1 B2055 ED (stationary rail parts)
NOTE: In Americas the Cable Support Kit must be provided locally by the Customer (e.g.
CPGE55 from Unistrut).
Optima IGS 320, Optima IGS 330 Pre-Installation Manual
Direction 5537562-1-1EN, Revision 3
134 3 Room Structural Requirements
To Next Page
Loading...
