3.2 Tools and Test Equipment
Refer toTable 1-2Table 1: .To obtain a list of tools and test equipment for components not
specified in , Table 1-2Table 1:refer to the appropriate component Pre-Installation Manual listed
in Chapter 2, Basic System Compatibility
Table 1:
Table 1-2:
PRODUCT OR COM‐
PONENT
TOOL OR TEST EQUIP‐
MENT USED FOR SOURCE RECEIVED (DATE)
LC Positioner Service Engineer's Tool
Case
General Use
Level, Protractor Type Positioner Checks
Plumb Line included in
46-216640G1
Positioner Checks
Torque Wrench 2 to 20
daN.m (15 ft. lbs. to 150
ft. lbs.)
Positioner Checks
1/2 inch Ratchet Wrench
(2)
Raise and Lower Posi‐
tioner shipping dolly
Wrench, Spanner
(46-176584P1)
High Voltage Cable In‐
stallation
Laptop Computer (MS-
DOS Windows)
Positioner Configura-tion
and Calibration
Status Display Same as for LC (Service Engineer's Tool Case)
Omega table Same as for LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as required
Installation dolly (PN
5265134)
General Use
X-Ray Head Same as for LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as required
System Control Cabinet Same as for LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as required
Ethernet adaptation kit
for laptop 2128794
General use (to be or‐
dered before delivery of
system)
DL User parts
Monitor Suspension
Optima IGS 320, Optima IGS 330 Pre-Installation Manual
Direction 5537562-1-1EN, Revision 3
Chapter 1 General Requirements 33
To Next Page
Loading...
