3.2 Floor Requirements............................................................................................................106
3.2.1 Floor requirements when using provided floor anchors.............................................106
3.2.2 Pan Type Floor Construction Requirement............................................................... 106
3.2.3 Hole dimension and preferred location in concrete floor........................................... 107
3.2.4 Water Pipe Requirements..........................................................................................109
3.3 Mounting Requirements..................................................................................................... 113
3.3.1 Floor Loading and Recommended Mounting Methods..............................................113
3.3.2 Positioner and Table Floor Mounting.........................................................................114
3.3.3 LC Positioner and Omega Table Floor Preparation Kits (GEMS supplied)............... 122
3.3.3.1 2285048 - Base Plate Assembly.......................................................................124
3.3.3.2 Assembly and separation select kit.................................................................. 125
3.3.3.2.1 2285051 – Above grade, Floor Anchors without insert............................ 125
3.3.3.2.2 2285646 – Through bolts without insert...................................................125
3.3.3.2.3 2286398 – On grade, Floor anchor..........................................................126
3.3.3.2.4 2285052 – Above grade, Floor anchor with insert................................... 126
3.3.3.2.5 2285053 – Through bolts with insert........................................................127
3.3.3.2.6 2285632 – Floor plate / Base plate assembly..........................................127
3.3.3.3 5570895- Base plate assembly Kit................................................................... 128
3.3.3.4 2285054 – Templates....................................................................................... 128
3.3.3.4.1 2285056 - A/C/N Templates.................................................................... 128
3.3.3.4.2 2186109 – EP Template.......................................................................... 128
3.3.4 Injector Mounting Requirements ...............................................................................130
3.4 Ceiling Requirements......................................................................................................... 131
3.4.1 Rail Mounting.............................................................................................................131
3.4.2 Bolt Specifications..................................................................................................... 131
3.4.2.1 Mavig suspensions........................................................................................... 131
3.4.2.2 Ergo suspension...............................................................................................131
3.4.3 Select Rails................................................................................................................132
3.4.3.1 Rails for Mavig suspension...............................................................................132
3.4.3.2 Rails for Ergo suspension.................................................................................134
3.4.4 Cable Support for Monitor Cables............................................................................. 134
Optima IGS 320, Optima IGS 330 Pre-Installation Manual
Direction 5537562-1-1EN, Revision 3
16 Table of Contents
To Next Page
Loading...
