– 54 –
13. Remove the eight 13-mm nuts and washers
(2 not shown) from the bolts that hold the
counterweights to the front of the outer tub.
14. Remove the top and bottom counterweights
from the outer tub.
15. Remove the 8 bolts from the slots in the outer
tub.
16. Remove the front dampers from the outer
tub. (See
Dampers.) Depress the dampers and
position them toward the outside of the cabinet.
17. Remove the twenty-two 8-mm hex-head screws
from the perimeter of the outer tub.
(Continued Next Page)
11. Disconnect the 3 heater assembly wires.
12. Remove the plastic wire tie that holds the heater
assembly wiring to the outer tub.
Note:
• Install new outer tub seal (Part # WH08X10023)
whenever tub halves have been separated.
• Use a torque wrench to tighten the twenty
two 8-mm hex-head tub screws to 45 in. lbs of
torque.
• When installing the front half of the outer tub,
ensure the heater is inserted inside the bracket
attached to the rear half of the outer tub. (See
Heater Assembly.)
19. Pull the wash basket out of the rear half of the
outer tub .
10. Remove the remaining 8 Phillips-head screws
that attach the front bracket and control panel
rear cover and position the bracket and cover at
the top rear of the washer.
Disconnect
Wire Tie
1 of 22
1 of 8
18. Press the 2 tabs (1 not shown) located on the
sides of the outer tub inward and remove the
front half of the outer tub.
To Next Page
Loading...
