CHAPTER 4: SOFTWARE
PQMII POWER QUALITY METER – INSTRUCTION MANUAL 4–11
4.4 Using the EnerVista PQMII Setup Software
4.4.1 Entering Setpoints
The System Setup page will be used as an example to illustrate the entering of setpoints.
Z Select the Setpoint > System Setup menu item. The following window
will appear:
When a non-numeric setpoint such as
CT WIRING is selected, EnerVista PQMII Setup
Software displays a drop-down menu:
When a numeric setpoint such as
PHASE CT PRIMARY is selected, EnerVista PQMII
Setup Software displays a keypad that allows the user to enter a value within the
setpoint range displayed near the top of the keypad:
Z Click Accept to exit from the keypad and keep the new value. Click on
Cancel to exit from the keypad and retain the old value.
Z In the Setpoint / System Setup dialog box, click on Store to save the
values into the PQMII.
Z Click OK to accept any changes and exit the window.
Z Click Cancel to retain previous values and exit.
To Next Page
Loading...
