– 58 –
Overview
When viewed from the front, the washer is shipped
for installation on the left and the dryer is shipped
for installation on the right. If the hose utility
connections are arranged so that the units must
be installed with the washer on the right and the
dryer on the left, the backsplashes of the washer
and dryer can be switched in order to maintain the
proper curved appearance.
To switch the washer and dryer backsplashes:
1. Place a towel over the lid of the washer to
prevent scratches to the surface.
2. Remove the 2 Phillips-head screws from the
washer backsplash.
3. Rotate backsplash forward and lift off.
Switching the Washer and Dryer Backsplashes
WARNING!
• Make sure the washer and dryer are unplugged.
• Turn both the home hot and cold-water valves
to the off position.
• Turn the home gas shut-off valve to the OFF
position (for gas dryer models).
Tools Needed
#2 Phillips-head
Screwdriver
Rear Cover
Screws
4. Remove the 2 Phillips-head screws holding
the backsplash to the rear cover. Remove the
backspash from the rear cover.
Towel (2)
To Next Page
Loading...
