– 8 –
Washer Features
_________________________________________________________________________________________
_________________________________________________________________________________________
_________________________________________________________________________________________
_________________________________________________________________________________________
Cycle Signal
Use the SIGNAL button to change the volume of the end of cycle
signal. Press the button until you reach the desired volume.
Soak
SOAK is an extra wash before the main wash. Use it for heavily
soiled clothes or for clothes with a care label that recommends
soaking before washing. Be sure to add high-effi ciency detergent,
or the proper wash additive to the soak dispenser.
Notes:
When selecting SOAK, it is recommended to use powder •
detergent in the main wash (detergent) compartment.
The maximum soak time is 3 hours.•
Extra Rinse
Use EXTRA RINSE when additional rinsing is desired to remove
excess dirt and detergent from soiled loads.
Delay Start
You can delay the start of a wash cycle for up to 24 hours. Press
the DELAY START button to choose the number of hours you want
to delay the start of the cycle, then press the START button. The
machine will count down and start automatically at the correct
time.
Note: If you open the lid when the delay is counting down, the
machine will enter the pause state. You must close the lid and press
START again in order to restart the countdown.
MY CYCLE
To save a favorite cycle, set the desired settings for wash cycle,
soil level, spin speed and wash temp settings and hold down the
MY CYCLE button for 3 seconds. A beep will sound to indicate the
cycle has been saved. To use your custom cycle, press the MY
CYCLE button before washing a load. To change the saved cycle,
set the desired settings and hold down the MY CYCLE button for 3
seconds.
Notes:
When using MY CYCLE, wash options cannot be modifi ed after •
the cycle has been started.
If you change wash options with MY CYCLE before starting the •
cycle, the MY CYCLE light will turn off and you will be returned
to the base cycle.
To Next Page
Loading...
Need help?
General