GFK-2847 QuickPanel+ User’s Manual–November 2013 33
Appendix A. Product Certifications & Installation Guidelines for Conformance
Appendix A Product Certifications & Installation Guidelines for
Conformance
The QuickPanel+ operator interface is intended for use in industrial environments and when
properly installed shall comply with the following agency approvals.
Agency Approvals
Agency
Description Standard Comments
or Marking
N.A. Safety for Information Certification by Underwriter's
Technology Equipment Laboratories to UL 60950-1and CSA
60950-1
Low Voltage Directive Self-Declaration in accordance with
European Safety for Industrial European Directives; Refer to
Control Equipment Declaration of Conformity found at
http://www.ge-ip.com/ for a complete list
of approved products
Electromagnetic Compatibility Self-Declaration in accordance with
Directive European Directives; Refer to
European EMC for Industrial Declaration of Conformity found at
Control Equipment http://www.ge-ip.com/ for a complete list
of approved products
Note: The agency approvals listed above and on the Declaration of Conformities are believed
to be accurate; however, a product’s agency approvals should be verified by the
marking on the unit itself.
Government Regulations
The FCC requires the following note to be published according to FCC guidelines:
Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.