Security Pro 500
15
• Opening and Closing reports
• Latchkey Paging
Pager Messages
When an event is reported on a numeric pager, the following information is included:
Although all three types of information can be reported on your pager, your pager service deter-
mines how the information will actually appear.
Event Code in Page
This part of the page let’s you know what has happened.
Sensor Number or User Number in Page
This part of the page let’s you know who or what is causing the event.
Code Indicates
009
A sensor has been restored to its non-alarm state
1 1 1
System has been disarmed
1 1 8
System trouble has been fixed
1 1 9
System alarm condition has been cancelled
222
System armed to Level 2
333
System armed to Level 3
a
a. If the user arms the system to level 3 (AWAY) the pager
will report that the system was armed to level 3 (333).
However, if the Auto Stay Arming feature is enabled and
the user does not exit the premises, the arming level will
revert to level 2 (STAY) without notifying the pager.
555
System phone test
888
System has a trouble condition
999
System is in alarm condition
Code Indicates
000
System event not caused by a sensor or user
001 — 024
Sensor numbers 1 through 24
600 — 615
User codes 00 through 15 used
678
System Master code used
679
Installer code used
680
Dealer code used
697
Quick Arm used
698
Keyswitch sensor used
699
System armed itself because it is being serviced or powered-up
S e n s o r n u m b e r o r u s e r n u m b e r
E v e n t c o d e L a s t f o u r d i g i t s o f c e n t r a l
s t a t i o n a c c o u n t n u m b e r
To Next Page
Loading...
