GE Senographe DS Operator's Manual

GE Healthcare Senographe DS Acquisition System
Revision 1 Operator Manual 5307907-3-S-1EN
Browser
8-browser.fm Page no. 75 Chapter 8
8-3 Medical Application preferences
Select this option to open one of the windows shown and described below to set Medical Application
preferences. To change a setting, click the button beside the option to switch it between selected ( or
) and deselected ( or ). After making changes, click Save to apply them or Close to leave the
window without saving.
Auto Push
Select Auto Push ON or OFF, the type of images to be transferred, and the name of the desired remote
host. Remote host information is set up by the FE at installation time.
Auto Print
Select Auto Print ON or OFF, and the name of the desired DICOM printer. Information on available print-
ers is entered by the FE at installation time. Click the Printing properties ... button to set printing proper-
ties if required (refer to Chapter 13 Printing). Only the default print mode of Fit to Film is available.
Note:
Film size used for autoprint is 8 x 10 inch
Auto Push
Save Close
OFF
Raw Proc Both None
loupiac
stamour
Remote Hosts
Auto Push
ON
MedAppPrefs
Auto Print Annotations Auto Windowing Quality Check Auto Delete Test Hosts Names Image Process.
Raw Proc Both None
Raw Proc Both None
Printer 1
Printer 2
ON
OFF
Printing properties ...
Number Of Copies (1.. 9)
Print mode
Fit to Film
DICOM printers
Save
Close
Auto Print
Auto Push Auto Print Annotations Auto Windowing Quality Check Auto Delete Test Hosts Names Image Process.
MedAppPrefs
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).

GE Senographe DS Specifications

General

Brand	GE
Model	Senographe DS
Category	Medical Equipment
Language	English